|
20140320
110V Double Knives Ice Shaver |
|
Ice breaker is a device used in ice cream shops for cold drinks,
which can be made into small pieces of ice.
|
1, ice crusher should be installed in sufficient supporting
force on the work table, and with the ground have an appropriate distance.
2, before turning on the power supply, first check the power supply voltage, and
the machine voltage is consistent, whether the socket meets the safety
standards, and has installed the leakage protection switch and connect the
ground wire. Confirm that all comply with the requirements of electricity.
3, before the boot, the ice will be broken to about 20 millimeters in diameter,
can be placed in the cylinder, above the convex over the mouth of the cylinder
should be appropriate. Note that the power switch is first opened until the
motor rotates with the power plate to allow the plate to move. The handle of the
pressure cap is pressed downward, and the ice blade is cut by fastening the
blade on the rotating cutter head. But the operation of the pressure cap handle
downward pressure shall not force too much, so as not to plug the motor, damage
to the motor. And should pay attention to the ice material after reducing the
margin, timely replenishment of new ice block.
4, chopped ice particles, through the discharge port into the disk. Should pay
attention to the material discharge smoothly, can not be blocked, otherwise it
will cause stuck knife disk, burn the motor. If the cutterhead is blocked, the
handle of the press cap should be brought up immediately, the switch is closed,
the plug is removed, and the trouble can be removed in time.
5, the ice thickness is by adjusting the blade mouth protruding cutter height to
achieve the adjustment of demolition of the first plastic disc protective switch
device, loosening screws bend, pull out the barrel, then loosen the fastening
screw cutter, remove the cutter, then loosen the compression screw blade
according to your requirements, installation in place, then, according to the
sequence of knife disc can be put back in situ.
|
- Voltage:110V
- Rated Power
:300W
|
|
|
1. To ensure safety, the ice block is not allowed to be pressed
directly by hand.
2, after each use, must be cleaned, cleaning should switch off the main
power switch, unplug the plug, and then use a clean towel to wipe the
water on the dryer. After cleaning, remember to lift the handle of the
press cap.
3, cleaning agents are not allowed to prevent contamination caused by
residues on the machine. Can not be washed directly with water, so as
not to damp the electrical components, affecting the safe use and damage
to the machine.
4, the motor design temporary cut rate is 80%, to avoid long continuous
operation. After an hour of continuous work, the work should be
suspended for twenty minutes before the work begins. This will greatly
extend the service life of the motor.
5, whether it is cleaning, maintenance, replacement blades, or cleaning
ice residue and other related work, should first turn off the power
supply, unplug the power plug; do not allow the captain time no-load
operation. |
|
|
Item
included:
110V Double Knives
Ice Shaver (152281)
|
|
Item## |
Description |
QTY |
Unit |
152281 |
110V Double Knives Ice Shaver
|
1 |
set |
|
Shipping & Handling Details
|